critikon dinamap vital signs monitor 8100/8100T



The Critikon Dinamap 8100 Adult/pediatric non-invasive blood pressure monitor measures systolic, mean, and diastolic pressures at preset levels, as well as pulse rate. Alarm and visual signals indicate when pressure goes outside preset limits. Various cuff sizes are available. DRE offers the Dinamap 8100 NIBP monitor refurbished.

The Critikon Dinamap 8100T vital signs monitor automatically measures systolic and diastolic pressure and pulse rate for adult, neonatal and pediatric patients. The 8100T also integrates into the standard blood pressure monitor a patient temperature probe, temperature display, connecting port, and operations keys. Blood pressure and temperature readings are independent and may be taken simultaneously. The temperature display takes the place of the Mean Arterial Pressure (MAP) display on the face of other Dinamap monitors; although MAP values are not displayed, they are still measured during blood pressure determinations and are available as data through the rear panel interface port.

The Dinamap 8100T runs either on AC power or on the internal rechargeable 12-volt battery. The battery will last a minimum of six hours with full charge, with a recharge time of approx. 16 hours. The pump automatically senses the particular hose and switches between adult/pediatric and neonatal blood pressure monitoring. Integral pole-clamp, mount on IV pole.


  • Ideal for adult, pediatric and neonatal monitoring.
  • Provides blood pressure monitoring with accuracy that correlates to central aortic pressures (as shown in clinical studies).
  • All vital signs measurements are automated, minimizing bias and inconsistencies between readings.
  • Special features save time and can make individualized patient care easier.

download brochure





  • Height: 8.75 inches (22.4 cm)
  • Width: 6.625 inches (16.9 cm)
  • Depth: 6.625 inches (16.9 cm)
  • Weight: 9.5 lbs (4.3 kg)
  • Determination Time: 20 to 45 seconds typical; 120 seconds maximum
  • Prior Data: Monitor stores 99 minutes of data (up to 100 readings within this period) while monitor is on.
  • Operating Modes: AUTOMATIC and MANUAL Modes. Pressing CANCEL will stop determination in any mode.
  • Power Requirements: Input power: 0.4 amps max at 100, 120 VAC amps max. at 220, 240 VAC
  • Input voltage: Domestic: 120 VAC/60 Hz, 104-132 VAC, 47-63 Hz. International: 100 VAC/50 Hz (nom.), 88-112 VAC, 47-63 Hz or 230 VAC / 50 Hz (nom.), 195-264 VAC, 47-63 Hz.
  • Battery: Six hour minimum operation (5 minutes auto cycle with adult cuff at 25°C) with full charge. Battery is 90% to 100% charged after 16 hours of charging.
  • Accessory Connection: Rear and panel data interface connector provides serial data communications interface at 600 BAUD.